View Full Version : SLC500 5/05 cannot apply 100Mbps full duplex
July 14th, 2010, 09:09 AM
I use SLC500 5/05 in my process but I cannot apply the Processor run on 100Mbps. I config it to use auto-negotiate but the processor still run on 10Mbps half duplex. Anyones can recommend me how to? Thank
July 14th, 2010, 09:33 AM
How about your switch, is this configured to 100 mbps ??
July 14th, 2010, 10:22 AM
Some of the older 5/05 cannot run above 10Mbps. Make sure your unit has a new enough ethernet daughterboard.
Can you post the firmware revision on the 5/05 label?
Compare that with what is shown in RSLogix 500.
July 14th, 2010, 10:25 AM
Thank I wiil post the pic later.