Hi,
Have anyone try a hand on AB GuardPLC? I'm from Malaysia and there is no proj. reference for this new GuardPLC.
I'm actually doing a protocol converting. Some data from this GuardPLC need to map into DCS (modbus). Anyone knows if the Ethernet port of the GuardPLC is using the same protocol/format like the ENET port on SLC 5/05 or 1756-ENBT?
If it's different, then I must converting from ASCII to Modbus and that will be killing also! Using ProLinx convertor.
Otherwise any good suggestions from you?....
Thanks.
Regards,
CK Chew
Have anyone try a hand on AB GuardPLC? I'm from Malaysia and there is no proj. reference for this new GuardPLC.
I'm actually doing a protocol converting. Some data from this GuardPLC need to map into DCS (modbus). Anyone knows if the Ethernet port of the GuardPLC is using the same protocol/format like the ENET port on SLC 5/05 or 1756-ENBT?
If it's different, then I must converting from ASCII to Modbus and that will be killing also! Using ProLinx convertor.
Otherwise any good suggestions from you?....
Thanks.
Regards,
CK Chew