ceilingwalker
Lifetime Supporting Member
Good day all. I have a Panel View 300 connected to a MicroLogix 1200. Could someone please tell me what software is required for programming this HMI? Thank you.
Panel View 300 Software
- Thread starter ceilingwalker
- Start date
shoelesscraig
Member
Panelbuilder32
ceilingwalker
Lifetime Supporting Member
OP
Thank you.
Ken Roach
Lifetime Supporting Member + Moderator
The cardinal rule for all PanelView questions is "post the entire part number", because there are several generations of products called PanelView.
If the PanelView 300 has a black bezel and relatively bulky frame, it's a PanelView Standard 300. That uses PanelBuilder32.
If the PanelView 300 has a grey bezel, it's a PanelView Component C300, which uses a web browser as a configuration tool.
If the PanelView 300 has a black bezel and relatively bulky frame, it's a PanelView Standard 300. That uses PanelBuilder32.
If the PanelView 300 has a grey bezel, it's a PanelView Component C300, which uses a web browser as a configuration tool.
shoelesscraig
Member
Ken's right...sorry, I didn't think about that possibility!
ceilingwalker
Lifetime Supporting Member
OP
It has the black bezel, thank you.
Similar Topics
Good morning,
I would have a question to ask you.
I have a Micrologix 1100 to which I have to connect a PanelView C300 in ethernet. I have...
Hi,
we are using PV300 and using Panel Builder 32 as software.
We are receiving the error code as 31.
Please let us know how to clear this error.
i have a panel view 300 whos cat no. is 2711-k3a5l1 i am using comm'' cable 2711-nc13(rs232)cable when i connect it to pc and pv 300 after that i...
Hello all, I have a panel View300 - Model: 2711-K3A17L1 B A 4.41 (AB)
By connecting it shows me 'ERROR 40' - Manual Error 40: Error firmware
(...
Hello everyone! I'm trying to hook up two HMI(panel view 300) to the same PLC (micro logix 1500) using the same port as the other port is connect...
