I'm trying to configure a flex I/O rack and ran into a few problems. The PLC is a 1756-L1 it's running REV 13.24. I configured the 1756-ENBT module and branched down from that is my 1794-AENT module. This is all seems to be working fine. When I right click on the 1794-AENT module to add a new module the 1794-IE12 module is not in the drop down. I'm guessing I'll have to configure it a generic flex module but I'm not sure. Anyone out there with experience in this area, any help would be greatly appreciated.
1794-ie12
- Thread starter dbucher
- Start date
OkiePC
Lifetime Supporting Member
You are correct, that in version 13, you need to select the generic profile.
If you have techconnect access, see Answer ID 33966
If you have techconnect access, see Answer ID 33966
Similar Topics
Hi all,
what is the proper way to fuse 1794-IE12 modules? fuse sizes/locations?
We are burning up these modules in our facility.
We are getting IO module fault on device status of 1794-IE12 module.
Please suggest if any solutions.
Good afternoon.
1794-ie12 module available, channel set to 4...20 mA.
According to the table from the manual, we get from 0 at 4mA to 30840 at...
Hi,
I have a 1794-IE12 FlexIO module connected via Ethernet/IP to a 1769-L24ER CompactLogix controller. The inputs are configured for 0-20mA and...
Hey guys, good morning !!
I have a doubt, I'm configuring a 1794-IE12 module using the 1794-TB3G base, using a 1794-ADN with 1756-DNB, the LEDs...