SHRB block problem

michlam

Member
M
Join Date
May 2010
Location
Planet Earth
Posts
3
Hello fellas

Im having trouble downloading this program to s7-200. (Se attachment)

No problem in program but just before it ends the download it shows up with a compiling error of the first SHRB block???

Any suggestions?

SHRB test.jpg
 
Long shot, but the example in the manual shows +4, have you tried entering +127


Edit - manual also states max length of shift register is 64 bits - that's your problem.
 
Last edited:

Similar Topics

Zombo
Siemens FC92 SHRB Shift Block
I want to use a shift register in S7 similiar to the Allen-Bradley BSL/BSR shift instructions. I found the FC92 bit shift register under standard...
2
Replies
17
Views
10,866
smartwildpig
S
K
Latching and SHRB TI505
I am using a SHRB for registers between 4082 to 4084. (see pic SHRB) I am using an interface to sometimes directly set values. So in the PLC...
Replies
0
Views
1,339
karivelm
K
K
SHRB (shift bit) TI505
I am using the SHRB instruction to shift bits with TISOFT. I was wondering if it is possible to set bits (by an interface) that are used by this...
Replies
3
Views
2,723
karivelm
K
T
SHRB function
What the SHRB funcion is used for????
Replies
1
Views
1,722
Zombo
Zombo
T
Terminal Block Cross Over Sorta
In the past, we have used AB 1492 feed thru screw terminals a lot. Lead time on these with our distributor is terrible. Is there an almost...
Replies
1
Views
109
d x l
D
Back
Top Bottom