cp5611a2 getting started

gtoka

Member
G
Join Date
Sep 2010
Location
Bs.As
Posts
20
Hey guys!
any manual about configuring s7300 and s7200 via cp5611 pci card? I´m reading the manual and there is no info of step7, and also there´s no wiring scheme. I only have a profibus cable rs485 both ends and im cabling the cp5611 to the mpi/dp port of a 314c-2dp with these cable, what i´m doing is wrong? i can´t program the cpu!
 

Similar Topics

Y
Difference between Siemens CP5611 and CP5611A2
Any Siemens experts care to enlighten?
Replies
5
Views
5,516
yxannes
Y
N
Getting page fault exception error.
The application was working in Twincat 4022.16 Used VM for offline. recently changed the laptop and the getting the error with Message as below...
Replies
0
Views
52
Nag
N
N
WINCC SCADA getting this error
We are using wincc scada WinCC system software V7.5 SP2 , connected to few plc . Past 3 weeks we getting this alarm continously when we checked...
Replies
0
Views
78
Nimi4576
N
B
My college lab was getting cleared out and there was no place for this controllogix rack, so I was able to take it.
I am very, very new to PLCs. I only have experience with Picos, but I knew enough to save this from the dumpster. Apparently, everything on it is...
Replies
13
Views
600
geniusintraining
geniusintraining
E
FX3U clone problem getting analog input/output to work
Hi, I tried today to get RD3A and WR3A instructions to work on the PLC and it didn't work, but it worked in simulation. I followed the clone...
2
Replies
18
Views
1,381
parky
P
Back
Top Bottom