bnburkhart
Member
Does anyone know where I can locate software and a manual for an older Mitsubishi FX2-32MT plc? I am new in the PLC world and am currently training on AB PLC's, so this one is a different format trainer for me at home.
Need Mistubishi Software
- Thread starter bnburkhart
- Start date
See this link, there may be something there you can use. There is an old DOS program listed on that site.
Since you are already using AB, I would suggest trying to find a used MicroLogix 1000 for training, unless you are just trying to increase your experience.
Link:
http://www.plcman.co.uk/downloads/
Since you are already using AB, I would suggest trying to find a used MicroLogix 1000 for training, unless you are just trying to increase your experience.
Link:
http://www.plcman.co.uk/downloads/
Last edited:
tragically1969
Member
All FX Series PLC's can be programmed with GX Developer (best option) or GX IEC Developer and an SC-09 cable to download\upload.
You could use Medoc as in the link above but its an old DOS based program.
You could use Medoc as in the link above but its an old DOS based program.
bnburkhart
Member
OP
I am just trying to expose myself to some of the older stuff that I might experience in the field. The trainers at the school I am attending are Micrologic 1000, 1500 and SLC 500. The FX was the main PLC type at my last job. Sounds like a hard one to learn starting out. Thanks for the help.
you can find a book done by John Ridley the name is Mitsubishi Fx Programmable Logic controlleres on this site
http://www.amazon.com/s/ref=nb_sb_noss?url=search-alias%3Dstripbooks&field-keywords=mitsubishi+fx.
it is a very helpfuul book
http://www.amazon.com/s/ref=nb_sb_noss?url=search-alias%3Dstripbooks&field-keywords=mitsubishi+fx.
it is a very helpfuul book
Similar Topics
I was wondering if anyone could help i am trying to use a SLC 500 with a 5/05 processor to set up an incremental encoder to a HSCE2 card? The card...
Decided to come to you all to see if any of you have any ideas on how to approach this issue.
I have a 'pack' of product that drops. When that...
I have an old Sentry Palletizer (S/O Number 3007 / Serial Number 1172) that has lost its program as the backup battery died years ago. I can...
So i've been at this for a long while, i have Citect Scada 2018, i have full access to everything but i can't seem to find any option or...
I've got this 3-phase 575V motor that we're controlling with a VFD (Variable Frequency Drive), which has been quite the learning curve in itself...