PLC S7 NTP Time Sync and Server

userxyz

Member
U
Join Date
May 2002
Location
any
Posts
2,768
All my PLC's should synchronize time and date with a time server (PC). I did this by using NTP sync in the HWconfig. This works, but, there is allways one hour difference. The PLC time is one hour further then the time it should be from the PC. I remember that I had similar problems a few years ago and I had to check the regional settings... these are set on Belgium...

What can I do to correct this ?
 

Similar Topics

I
Control Logix Redundant PLC System NTP Sync AOI
Hi sir. We are using Control logix redundant PLC system which supports only PTP time synchronization protocol but from DCS side we are receiving...
Replies
1
Views
2,414
harryting
H
J
Siemens NTP sync PLC VS. HMI
Hey guys, am I over looking something here? I have my Siemens PLC's (300's) synced with a NTP server. The PLC gets the UTC time from the server...
Replies
2
Views
5,591
JOLTRON
J
S
PLC and NTP
Hi, Are PLC to use the NTP protocols suite. I find very few information about PLC & NTP. Thanks a lot.
Replies
1
Views
3,072
Contr_Conn
Contr_Conn
M
HOW to communicate with OPTIX and Mitsubishi's Q Series PLC?? PLEASE HELP ME
HOW to communicate with OPTIX and Mitsubishi's Q Series PLC?? PLEASE HELP ME
Replies
0
Views
29
MIIN
M
S
Plc power indicator on but run and error indicators off
Hello..I am new to Plc.I have Mitsubishi Melsec Fx3Ga-40MR PLC controlling a machine for packing powder.Currently the Plc has issue which power...
Replies
3
Views
109
parky
P
Back
Top Bottom