Hi all,
Although I'm an electronics engineer, I'm new to PLC's ! and am in the middle of doing a course. One of the questions I came across while doing it was:
What is wrong with the following program?
| 0.00 1.02 1.01 0.02 1.02 0.07
|---|/|-------||-----|-------||-----|/|--|----|/|-----O--|
| | |
| 1.03 0.04 | 1.05 |
|----||-------||-----|-------|/|---------|
|
My answer to this was that there are two contacts that are addressed the same (1.02) on the same rung.
Apparently there is another fault, but i can't seem to find out what it is???
Anyone??
Thanks alot
Bri
Although I'm an electronics engineer, I'm new to PLC's ! and am in the middle of doing a course. One of the questions I came across while doing it was:
What is wrong with the following program?
| 0.00 1.02 1.01 0.02 1.02 0.07
|---|/|-------||-----|-------||-----|/|--|----|/|-----O--|
| | |
| 1.03 0.04 | 1.05 |
|----||-------||-----|-------|/|---------|
|
My answer to this was that there are two contacts that are addressed the same (1.02) on the same rung.
Apparently there is another fault, but i can't seem to find out what it is???
Anyone??
Thanks alot
Bri