michaeleme
Member
I bought Square D 8003 micro PLC to perform small project, and I cannot program it yet. If anyone having informations , please help me; and thank you all . 
Help me "Square D"
- Thread starter michaeleme
- Start date
See this thread, especially post 4 and 5. Also check the links in those posts for interface cable information.
http://www.plctalk.net/qanda/showthread.php?t=57669&highlight=micro-1
Link to manual:
http://ecatalog.squared.com/pubs/Automation%20Products/SYMAX%20Programmable%20Controller/Micro%20Programmable%20Controllers/30598-788-01A1.pdf
I'm not sure but I believe IDEC manufactured this device and Square D private-labeled it.
WindLdr software may program it as a Micro-1 type plc. If that model doesn't work, try selecting Micro-3, or FA-3S type plc.
Link to Technical library:
http://products.schneider-electric.us/support/technical-library/
Type 8003 in their Search Box.
http://www.plctalk.net/qanda/showthread.php?t=57669&highlight=micro-1
Link to manual:
http://ecatalog.squared.com/pubs/Automation%20Products/SYMAX%20Programmable%20Controller/Micro%20Programmable%20Controllers/30598-788-01A1.pdf
I'm not sure but I believe IDEC manufactured this device and Square D private-labeled it.
WindLdr software may program it as a Micro-1 type plc. If that model doesn't work, try selecting Micro-3, or FA-3S type plc.
Link to Technical library:
http://products.schneider-electric.us/support/technical-library/
Type 8003 in their Search Box.
Last edited:
Similar Topics
Hi,
We are getting an intermittent 20001 error on our old SquareD PLC. It has 3 remote racks in close proximity and every few hours seems to drop...
please help me . I have to make this ladder diagram and I can’t figure it out :(
Hi Everyone,
i was hoping for a little help with this module. i have data that needs to be read from a different plc through the Modbus plus...
Hello,
I am trying to replicate a piece of logic on the PLC5 onto an SEL RTAC. I am using ladder on SEL and FBD. I am having issue on the ladder...
HOW to communicate with OPTIX and Mitsubishi's Q Series PLC?? PLEASE HELP ME