Omron CP1E-N TXD problem.

elessarsst

Member
E
Join Date
Jan 2011
Location
Expansion Socket
Posts
5
Hi all

I can successfully send data to plc with built-in RS-232.
But Transmit signal is not far enough.

Code: 
Baud Rate : 9600 or 38400 (38400 made it better but again bad result)
Data bits : 8
Parity    : None
Stop bits : 2

I've changed these values to have some variations. But The result is:

Sending data: 0x003c
Received data: 0x008B or sth like that..

I've just cut an oem rs-232 cable and connected right pins as OMRON wiring should be.
If the plc receives the right value there shouldn't be a wiring problem i guess.

My question is what is the best configuration for omron CP1E built-in rs-232.

Ty.
 
How "far" are you trying to transmit?

What device are you trying to communicate with?

Typically these kinds of issues are mismatched comm parameters or cabling issues.

Hope this will help.
 

Similar Topics

B
Problem with delayed switch on of omron sysmac cp1e
Hello. I have a problem with omron sysmac cp1e controller delayed start. The controller has been working on the punch press since 2016. Recently...
Replies
1
Views
756
tdoa
T
K
Omron CP1E Ethernet (TCP/IP) communication
Hi, I need to communicate omron CP1E PLC with SCADA to get the status of the machine. There is no etherent port available but an empty expansion...
Replies
2
Views
1,598
karthiknd7
K
J
how to factory reset omron CP1E
Hello... I remove one CP1E from old useless machine and I would like to use it with something else....but it is locked/have no pass/....How can I...
Replies
0
Views
1,438
Jirrr
J
R
omron cp1e real time clock
hi all i have used a real time clock to turn on a bit after 1 month. the plc was off for this whole month and when i turned on the plc after a...
Replies
2
Views
1,417
RAJNAIK
R
C
Omron CP1E Communication Issue
We had a CP1E go bad (power issue). Installed spare and could not get it to communicate to our motion drive via add on RS485 card. Tried...
Replies
5
Views
1,484
gtsuport
G
Back
Top Bottom