AB 1734 AENT Status display on HMI

logicinn

Member
L
Join Date
Apr 2007
Location
lohami-hagetaot
Posts
19
Hello
im trying to build a screen wich will display the status of all remote IO modules in the Factroy .
my problem is that im not sure which tag in the PLC will do the job
i know that tere is the "SlotStatusBits0_31"&SlotStatusBits32_63 but not sure how to translate the data.
can some one explain or direct me to relevant documentaion
thank you in advance
and sorry for my spelling
 

Similar Topics

Q
1734-AENT Network status: solid red
Hello I am new to PLCS.net, I have a question here in regards to the Network Status light being solid red on the 1734-AENT. I checked the manual...
Replies
2
Views
1,734
pturmel
P
H
1734 AENT Network Status Flashing
Hello again, I have a 1734 AENT point IO adapter hooked up to an ethernet switch through a NAT device. All of my indicator lights are solid green...
2 3 4
Replies
49
Views
12,887
plvlce
P
K
1734-AENT Module Status solid red
Kindly, we have the following module with its Module Status led solid red. What can we do to solve this? " POINT I/O EtherNet/IP Adapter Module ...
Replies
6
Views
3,943
pal
P
A
Point Bus Status in 1734 AENT Point IO.
Some times in running condition of the PLC, the point bus status become solid red and network status blinking green due to that total system...
Replies
1
Views
5,256
mike_dr
M
U
Point IO 1734-AENT(R) LED Status
Hi All, I´ve been trying for a while but without much luck. I would like the monitor the 4 LEDs on the front of a 1734-AENT(R) module. They are...
Replies
8
Views
6,194
wcjcpy
W
Back
Top Bottom