Hello,
I've problem with connection between Omron touch screen NP5 and Mitsubishi Melsec-A, use its programming port.
Cable connection is correct, according to manual. Use RS422 with 9600, 8, Odd, 1 (COM2 on NP series). Dip switches set on NP are correct.
But still can't communicate between them, host PLC error.
Is there any setting must be consider ?
Thank you
I've problem with connection between Omron touch screen NP5 and Mitsubishi Melsec-A, use its programming port.
Cable connection is correct, according to manual. Use RS422 with 9600, 8, Odd, 1 (COM2 on NP series). Dip switches set on NP are correct.
But still can't communicate between them, host PLC error.
Is there any setting must be consider ?
Thank you
