Compact Logix and printer
- Thread starter gregmiko
- Start date
Steve Wiebe
Member
- Join Date
- Jul 2002
- Posts
- 68
We use Sato printers here and at about 8 other mills.
We don't use the auto cutters but they are an option.
Most of these printers use Ethernet but they connect
to a computer not to a PLC directly.
I wrote the programs in Delphi and I could strip one down
and post it if you wish.
Steve
We don't use the auto cutters but they are an option.
Most of these printers use Ethernet but they connect
to a computer not to a PLC directly.
I wrote the programs in Delphi and I could strip one down
and post it if you wish.
Steve
Similar Topics
I have a system that uses a compact logix processor. I use a RTA 435NBX ascii gateway to send a sting to an Intermec PM43 printer. This system...
Hi all,
I've been asked to quote a system involving a zebra printer on a compact logix. Nothing too complicated, just need to set it up to print...
I am looking for some feedback or recommendations on being able to print from 1769-L32E to an Ethernet Zebra Printer.
Any examples of your setup...
Hi friends,
I want to configure compact logix L32E PLC with S4M00-2004-0200T Zebra printer on ethernet network, and i want to send some data...
gents, I am trying to configure communication with EMERSON PK300 controller through port A1 using generic ethernet communication module . I could...