ocarnero71
Member
hi there, can some body help me, i need to know if i can connect npn signal to the input and output of a s7 226 siemens plc.
s7 200 ports communication
- Thread starter ocarnero71
- Start date
http://ramcosensors.com/pdf/NPN to PNP Converter Modules/RCM Series/RCM1.pdf
use convertor in middle of the circuit before input and output module
check the above link
use convertor in middle of the circuit before input and output module
check the above link
ocarnero71
Member
OP
Thanks
Similar Topics
hello
I'm new.Sorry, my English is not good.
Can someone tell me how i can monitor plc program having to connect two td 200 display panel from...
hello
can someone tell me how i can monitor plc program without having to unplug td 200 display panel from communications port
the plc only has...
I know that Siemens have their own supports for where the Network/Profitnet cable enters the S7-1200 range, but they don't support standard...
Hi everyone,
This is probably a dumb question (but I'm not that experienced with Siemens systems). One of our customers claims that there...
Hi.
I have a 222 CPU. I need to recover the program from the eeprom memory. Is it possible?