We have several plc's networked together by controlnet and to better understand it we are building a training module.The Module consists of two racks with processor and one drive. Do i need to use t-taps on every thing? Or what do i need to set this up. Like i said this is for traing purposes. Thanks guys.
ControlNet question
- Thread starter icehube
- Start date
rdrast
Lifetime Supporting Member
For reliable comms, yes, use the taps everywhere, and keep the shield isolated from ground.
For demo/bench testing, I've found that plain old BNC T connectors mostly work.
For demo/bench testing, I've found that plain old BNC T connectors mostly work.
Similar Topics
So we have an older system which runs on controlnet. It’s a logix 5000 based system with about 8 powerflex 40P drives. One of them I have to...
I'm specking out requirements/costs for a new machine to be built later this year. I plan on using Controllogix for the PLC control. My question...
I was wondering if there is a way to get the amperage from a powerflex 700 over controlnet to an hmi or even wonderware? Any suggestions thanks.
Hi all,
I have a question:
1) What causes the Controlnet node fault?
Greetings,
I've done a couple of smalll ControlNet projects, so I am somewhat familiar with the technology.
I'm looking at designing a couple...
