Siemens Logo with Coros OP5

vatsal12

Member
Join Date
Nov 2010
Location
Ahmedabad
Posts
1
Hi,

We have installed Logo in one project.
I want to connect Logo 230RC PLC with Coros OP5 HMI.

Is there any possible way to connect them ?

Thank you,
Vatsal Shah
 

Similar Topics

Hi all, First, thank you for reading the thread. So I had a task as the following: An up-counter must be programmed as part of a batch-counting...
Replies
7
Views
239
Hi Lads, I want to implement a flood prevention system with my domestic water pump. The intention is to have the water pump cut off on a daily...
Replies
7
Views
1,022
We need a Really Simple and Cheap controller that has a display or a Web Interface where we can change some set points. We were thinking about a...
Replies
2
Views
989
hello i have LOGO! 12/24RCE and i am looking for a schematics of electronic board. Or if someone know what is the burned component on the photo.
Replies
4
Views
1,376
Hi, I'm no expert in PID regulating so I need some advise. I have a VFD controlled deepwaterpump that is maintaining the pressure in a closed...
Replies
24
Views
11,821
Back
Top Bottom