s71200, iFix SCADA, MODBUS

sijilvv

Member
S
Join Date
Jul 2008
Location
KERALA
Posts
3
I would like to know if i could communicate s71200 with Ifix Scada by Modbus Protocol. I have communicated s7200 with iFix Scada before. At that time I have used MB1 Driver. I have been trying to communicate s71200 with ifix through MB1 driver but it is not going good. Can anyone help me..............please

Thanks
 

Similar Topics

N
Requirements to communicate S71200 & Ifix 32
Hi, I got a proposal to develop a project where Ifix 32 has to be configured instead of a HMI that i already programmed. I studied that S7A...
Replies
0
Views
1,474
Nelliyan
N
J
SEW EI7C encoder to S71200 PLC
Hi Folks. Has anyone used an SEW EI7C encoder with an S71200 PLC? If yes, how is it done? I use this same encoder in EI76 mode with a...
Replies
0
Views
260
jmartin9
J
B
Shift register help, Siemens s71200
Hi everyone I am completely new to using shift registers and am a bit stuck, my shift register works as should, it is for an overhead conveyor...
2 3 4
Replies
55
Views
15,594
parky
P
H
S71200 TCP/IP communication with scanner card
Dear Experts, Warm Greetings ! By using TCON,TSEND,TRCV,TDISCON block,I am trying to make communication with my...
Replies
1
Views
1,492
hema
H
Ricardo Carmo
Scheneider M241 Modbus tcp/ip connect S71200 siemens
Hello; i'm having some troubles with a com test i'm handling. i have another end for it, but for now i would like to have : M241 in io_scanning...
Replies
4
Views
3,484
Ricardo Carmo
Ricardo Carmo
Back
Top Bottom