GE FANUC VersaMax Programming

sajay_surya

Member
S
Join Date
Jun 2011
Location
Erode
Posts
1
Hello,

I have a VersaMax micro PLC. I would like to program it in the Structured text language. I tried with VersaPro but could not do that. I heard that it could be done in Proficy - CIMPLICITY Machine ediiton. Could anyone brief me how?

Thanks and Regards
Sajay
 
The VersaMax micro can only be programmed in Ladder and Instruction List.

Structured Text is available on the Rx3i and Rx7i.
 
You can use "Instruction List" (IL) if you want an alternative to Ladder.
Proficy ME has all you need in its online help to get started.
 

Similar Topics

S
Programming Software for GE Fanuc Versamax?
Hello all, My first post here and thanks for the excellent resource of information witch has been a huge help too a new programmer like myself...
Replies
3
Views
14,889
Andratch
A
K
Fault link blinking in GE Fanuc IC200PNS002-AC Versamax Network Interface Module
I have one GE Fanuc IC200PNS002-AC Versamax Network Interface Module and the fault red light is blinking and i have checked in manual it is...
Replies
9
Views
192
Steve Bailey
Steve Bailey
L
GE FANUC VERSAMAX Micro Controller
Hi. I have an Ge Fanuc Controller versa max and need to know where i can download the software for this PLC, anyone that can direct me please. I...
Replies
2
Views
1,200
LionHeart
L
K
GE Fanuc VersaMax Interface Software?
Hello, This is probably an easy question—or at least I hope it is—and it will show how green I am. I've been tasked with troubleshooting a GE...
Replies
1
Views
3,241
Steve Bailey
Steve Bailey
D
Versamax micro Plc Ge fanuc
Every time i turn off and turn on the PLC, PLC is not going to RUN mode In the fault table it shows error " system Configuration mismatch" And...
Replies
4
Views
1,747
Steve Bailey
Steve Bailey
Back
Top Bottom