SouthPahw
Member
I posted this on a reply in another thread, but with now responce thought I should seperate the issue.
Info: I am using Syswin, have the correct Cable and Host Links.
I have succesfully uploaded two different programs from C20 units.
Problem is with:
● OMRON C200H CPU01 C200H-ME831 Memory Unit EER-ROM 16kb
Using C200H-LK201 host link unit.
I can get on-line and connected; But I can not upload program.
I have gone thru manuals and tried every C200 option in Syswin.
It will start upload; then get a message:
"Command Not supported in Current PLC
You may have the wrong PLC Type"
As I said, I tried all the C200 options. I can Change the PLC Modes with no problem.
The only thing I even found close in manual was really applicable to downloading programs, but It said some C200H's had to have the I/O configured.
So I set up the off-line program with the current PLC I/O and C200H in project setup. Same issue.
Any suggestions? What am I missing?
Thanks.
Info: I am using Syswin, have the correct Cable and Host Links.
I have succesfully uploaded two different programs from C20 units.
Problem is with:
● OMRON C200H CPU01 C200H-ME831 Memory Unit EER-ROM 16kb
Using C200H-LK201 host link unit.
I can get on-line and connected; But I can not upload program.
I have gone thru manuals and tried every C200 option in Syswin.
It will start upload; then get a message:
"Command Not supported in Current PLC
You may have the wrong PLC Type"
As I said, I tried all the C200 options. I can Change the PLC Modes with no problem.
The only thing I even found close in manual was really applicable to downloading programs, but It said some C200H's had to have the I/O configured.
So I set up the off-line program with the current PLC I/O and C200H in project setup. Same issue.
Any suggestions? What am I missing?
Thanks.