Hi,
Can anyone help me with this old DOS programming tool for ABB Procontic PLCs.....
I have the original PLC code, programming manual and can communicate succesfully with the PLC and the code matches. However despite any number of attempts/approaches I cannot simply change a constant variable (KW) on a function block to another variable of the same type. I have the highest access level and have done what it says in the manual to change the variable but all I get is the following message:
Connection/variable not allowed
Pulling my hair out as this should be straightforward. Hope somebody out there has used this product and can point me in the right direction!!
Many thanks
Dave (deeside)
Can anyone help me with this old DOS programming tool for ABB Procontic PLCs.....
I have the original PLC code, programming manual and can communicate succesfully with the PLC and the code matches. However despite any number of attempts/approaches I cannot simply change a constant variable (KW) on a function block to another variable of the same type. I have the highest access level and have done what it says in the manual to change the variable but all I get is the following message:
Connection/variable not allowed
Pulling my hair out as this should be straightforward. Hope somebody out there has used this product and can point me in the right direction!!
Many thanks
Dave (deeside)
