ABB Procontic K200 - software

Hello Everybody!

I'm looking for a programming software for a very old PLC, an ABB 07 KR 264 from the Procontic K200 series (907PC322 is the name of the programming software).

The PLC is so old, that it says " BROWN BOVERI " on the front plate. I've found some docs about it and found out that it was taken over by ABB.
http://www.vaeprosys.cz/TD_ridici_systemy.htm#K200
Unfortunately I was not able to find the software on the net!
Is it possible to program it with a PC trough RS232 ?
Any help is welcomed!

Best regards,
Attila
[email protected]

Procontic K200 - cable

Hello!

I'm back again.
My question is now:
it is possible to connect to a 07 KR 264 with a PC without that programming console 07 PG 201 ?

Best regards,
Attila

Abb 07 kr 264

My name is Predrag from Serbia and I have a problem with ABB PLC 07 KR 264.I need software for label 907PC332 with him. Do I have to help? Greetings.

Hello Predrag!

I got some info last year from the ABB helpline. This is what they said:

"Hello,

you can find the docs here
http://www.abb.de/plc

also here
http://www.vaeprosys.cz/

The prg. soft is 907PC32 -systemspecific K200.

Best regards

PLC-Support"

Eventually they've sent me some files but I've never used them, because according to the manuals I would've needed that handheld programming console between the PLC and a PC to be able to connect.
So I had to replace the PLC with a new one and write a new program. This is what I also recommend to you if you do not have that programming console.

Here is the e-mail address of the ABB helpline (they were very helpful):

[email protected]

Best regards,
Attila Tamas

Good Morning,
I'm new. I do not know if it's okay here.

Anyone have or know where to find the Programmig SW for the Procontic b System?
Regards, Patxi.