cornbread
Lifetime Supporting Member
Any one have expereience in hooking up WAGO I/O to a Compactlogix via profibus? Looking for program examples.
WAGO Comapctlogix and Profibus
- Thread starter cornbread
- Start date
LadderLogic
Member
Wago has an Ethernet/IP coupler which, if I am not mistaken, should be much better supported on Allen-Bradley side. Why Profibus?
I have definitely seen wago profibus hooked up to siemens not compactlogix.
We use the devicenet wago slave and IO for our kuka and ABB robots. Used a wago ethernet-modbus over Tcp/ip to talk to a proface screen don't know but I think there is a ethernetIP module.
Better of using AB same price !
Only a suggestion.
We use the devicenet wago slave and IO for our kuka and ABB robots. Used a wago ethernet-modbus over Tcp/ip to talk to a proface screen don't know but I think there is a ethernetIP module.
Better of using AB same price !
Only a suggestion.
LadderLogic
Member
If the original machine had Wago "slice I/O" on Profibus, it still might be easier to replace the Profibus bus coupler with an Ethernet/IP one (or anything else CompactLogix will be easy to to handle, like maybe DeviceNet).
If we are talking about Wago IP67 Profibus I/O modules rather than "slice I/O" terminals... well, then you might have a problem.
Similar Topics
Hello,
I am in possession of a WAGO PFC 200 750-8216 which I was successfully able to set up as a Modbus RTU Master to a slave device using...
I have a project to setup base programs across multiple PLC platforms that can be used for Modbus communications to various sensors that have...
Hello,
I m having a problem with wago 750-862 plc.
The plc won't start automatically in run mode after a power reboot.
I've also tried the...
Hello everyone, I am trying to setup a Wago 750-8100 PLC to send a text message out via ethernet port, if I get a Digital input that is true. I...
How do you set up a message block for a REMOTE IO unit? (using ethernet IP)?