Neuadan
Member
Hi
I have a Mitsubishi Q12H cpu with a QJ71PB92V profibus master and a Robot controller I/O. I am using gx developer v8.0 and dp configurator 7.0.
I downloaded the setup using the dp configurator and have a solid green Run light, Flashing SD/RD light, Solid Ready light, and a Solid Token light.
I know I to use a move function or TOP function to get the data too and from the PLC but I am not seeing change of states to the D1000 area that is listed in the DP configurator I/O setup.
Someone earlier had a simalar issue and there was a easy profibus setup guide that got sent to him in a link but that as long since ceased to be a valid link.
I have a Mitsubishi Q12H cpu with a QJ71PB92V profibus master and a Robot controller I/O. I am using gx developer v8.0 and dp configurator 7.0.
I downloaded the setup using the dp configurator and have a solid green Run light, Flashing SD/RD light, Solid Ready light, and a Solid Token light.
I know I to use a move function or TOP function to get the data too and from the PLC but I am not seeing change of states to the D1000 area that is listed in the DP configurator I/O setup.
Someone earlier had a simalar issue and there was a easy profibus setup guide that got sent to him in a link but that as long since ceased to be a valid link.
