Pressure Transducer on DL205-1 F2-08AD-1

Pressure Transducer is a FPG2CR,2D5D6A SENSOTEC,
Range: 500PSIG
Supply: 9 - 28 VDC
Output: 0 - 5 VDC

A (+) Supply
B (-) Supply return
C (-) Output 0 Vdc to
5 Vdc
D (+) Output
E No connection
F No connection

I HAve wired up pins as according:
A = RED
B = BLK
C = GRN
D = WHT

my question is that, am I to wire together pins B and D together?

I connected pins
A to +12.24V on PLC Power supply
B to 0 VDC on Analog Card
C CH 1.
D is that to be connected to 0 VDC as well?

Treat the supply as floating. A&B are power supply only.
C&D go to Analog card only. If polarity is wrong, swap C&D.
IF that doesn't work, then treat the supply an non-floating. Wire A&B to the same power terminals as the analog card. All 4 leads will be going to the analog card.

I'm just confused about the card since it only has channel inputs ie

0V
24V
ch 1+
ch 2+
ch 3+
ch 4+
ch 5+
ch 6+
ch 7+
ch 8+

Pins A B are on 24 and 0 V
Pins C D are on ch1 and 0 V

keithkyll said:

Treat the supply as floating. A&B are power supply only.
C&D go to Analog card only. If polarity is wrong, swap C&D.
IF that doesn't work, then treat the supply an non-floating. Wire A&B to the same power terminals as the analog card. All 4 leads will be going to the analog card.

Click to expand...

got this working now trying to convert value from pressure transducer into psig thank you .