servo motor

jgonsison

Member
J
Join Date
Oct 2010
Location
Angeles City
Posts
15
Hello Everyone,
i need to switch servo motor&driver to higher inertia for increased capacity. Do i need to increase the pulse output of the controller or just changing motor&driver to 400watts from 200watts will do it?
 

Similar Topics

W
Issues with Servo Motor Stopping ( Kinetix 5500 )
Hi all, New here and new all round to PLC`s. We have a servo drive that runs a cross travel beam backwards and forwards. I am having trouble with...
Replies
3
Views
188
robertmee
R
S
Servo motor
My servo motor instruction is not being executed on the gx works 3 even after the positioning parameters have been set
Replies
0
Views
120
Sudhiksha
S
S
Omron 1S Servo Motor Target Position Setting Out of Range
Hi All. I am setting up an Omron 1S Servo Motor to drive a conveyor. It goes forward 200mm, pauses and repeats until it is stopped. However...
Replies
3
Views
737
Peter Nachtwey
Peter Nachtwey
T
AB Servo Motor Keeps tripping out on excessive velocity error
Hi all, I am having a problem with my servo motor and I'm absolutely stuck as to why it wont run. Without any gearbox or any load attached to...
Replies
9
Views
3,646
tetcie
T
B
AMCI Servo Motor
We are currently experiencing a fault on 1 of the 3 stepper motors, keying mismatch fault. The stepper motor is SMD23E2-240A-M12S. We bought the...
Replies
8
Views
1,352
Brendana22
B
Back
Top Bottom