program cleared

basharath

Member
B
Join Date
Mar 2010
Location
hyderabad
Posts
103
dear all,
ge micro plc udr005 program got cleared autimatically...though the program was in flash.why is it so?

what can be the cause if plc takes the inputs(as can be seen by led's) and does not give any outputs even though its in run mode

thanks..
 

Similar Topics

M
Program Cleared / Default Program Loaded
Hi all, We had a fault this morning, and I was hoping someone might have some thoughts. Processor: 1747-L542B SLC 5/04 32K Memory Corrupted ROM...
Replies
4
Views
2,302
ArikBY
ArikBY
R
S7-200 recovery program from eeprom
Hi. I have a 222 CPU. I need to recover the program from the eeprom memory. Is it possible?
Replies
0
Views
11
Rafa1976
R
K
use Simotion D ethernet port as gate to access S7-1500 plc program
Can we use a Simotion D455 ethernet port x127 as a gate, to access S7-1500 plc Tia Portal program ? In the Simatic manager, we used Netpro to do...
Replies
2
Views
75
mk42
M
C
Need Help Accessing/Printing a Program - CIMPLICITY
Hi all, I am having issues accessing my Cimplicity software - the site code changed after re-install and I am no longer able to attain a new key...
Replies
10
Views
158
Steve Bailey
Steve Bailey
E
PLC Wiring and Program Review
Posted this to Reddit with little success, so I figured I would share it here as well. Very new to PLCs, but figured I would give it a shot to...
Replies
0
Views
115
eerielayne
E
Back
Top Bottom