PLC MX2 inverter communication

TheBeast

Member
T
Join Date
Sep 2011
Location
Ally
Posts
3
Hello everybody,

I have a small project: I am currently using a CP1L PLC from Omron and a MX2 Inverter from Omron.

These are connected via a RS485 / modbus comm port.

My question is how can I let my PLC communicate via CX-programmer with this MX2 Inverter via RS485.


Hopefully one of you guys can help me with this problem
 
You will need to setup the Drive comms
this can be done with CX Drive
 

Similar Topics

J
PLC CP1L with CJ1W-CIF12 connected to OMRON MX2 drivers
Hello, I have an installation with an omron plc CP1L with a CJ1W-CIF12 module connected to eight omron MX2 drivers. I use the bus to modify the...
Replies
2
Views
2,147
joserc
J
K
OMRON PLC interface with an OMRON MX2 drive
Hey Fellas! I am trying to interface an OMRON Cp1L 30 I/O PLC to an OMRON MX2 drive. The application is fairly simple, I have two outputs...
Replies
7
Views
2,612
kulgauravkanade
K
T
PLC Delta DVP 12SE and HMI Kinco GL043E not propperly connecting
Good Day to all of you, this is my first post, i will try to explain as best as possible, english is not my natural language. I am performing an...
Replies
0
Views
20
Tecnolaundry
T
Mas01
S7-TIA Portal: How can I make a project if I've only got the code loaded on the PLC?
Hi All, Someone at work has put a PLC system on my desk, that's just been taken off an idle production line. He said "It's an S7 PLC. We don't...
Replies
3
Views
81
mk42
M
A
ATS using a PLC
I have a project to automate four generator sets. The system will monitor and store the load demand of the factory. Once there's Power outage, the...
Replies
0
Views
45
Alibaba07
A
Back
Top Bottom