Micrologix 1100 and PV600

I'm being asked to integrate a fairly simple solution, but haven't programmed a PLC for years from scratch. I'm using a ML1100 with a PV600 for the HMI display. I have one analog input, 0-5 Vdc range, and that is literally it. No expansion slots, no cards, just the base. I'm going to use 1 of the two onboard IA's for the xmtr input.

Before I get too involved in asking questions, I wanted to know if there was a document or a tutorial somewhere I could use to help while I re-familiarize myself with all of this ? I just need to set up this one analog point, add a counter and a reset function to the HMI.

Thanks.

See below for links to the ML1100's manuals.

What is the complete catalog number of your PanelView?

http://literature.rockwellautomation.com/idc/groups/literature/documents/rm/1763-rm001_-en-p.pdf

http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1763-um001_-en-p.pdf


And here is a resent thread about the ML1100's base unit analog input.

http://www.plctalk.net/qanda/showthread.php?t=66525

Mickey said:

See below for links to the ML1100's manuals.

What is the complete catalog number of your PanelView?

http://literature.rockwellautomation.com/idc/groups/literature/documents/rm/1763-rm001_-en-p.pdf

http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1763-um001_-en-p.pdf


And here is a recent thread about the ML1100's base unit analog input.

http://www.plctalk.net/qanda/showthread.php?t=66525

Click to expand...

Thanks for the reply. The Panelview part number is ; 2711C-T6C.

I'll take a look at these manuals.

The 2711C is a "Component" PanelView terminal, built specifically for use with MicroLogix family controllers. The editing software is either accessed using a browser or by using the "Connected Components Workbench" launcher.

The PanelView Component "Quick Start" document is a good place to start:

http://literature.rockwellautomation.com/idc/groups/literature/documents/qs/2711c-qs001_-en-p.pdf

Ken Roach said:

The 2711C is a "Component" PanelView terminal, built specifically for use with MicroLogix family controllers. The editing software is either accessed using a browser or by using the "Connected Components Workbench" launcher.

The PanelView Component "Quick Start" document is a good place to start:

http://literature.rockwellautomation.com/idc/groups/literature/documents/qs/2711c-qs001_-en-p.pdf

Click to expand...

Thanks Ken, I think that part will be a little easier. Its just been years since I've programmed a PLC, and when I did, the apps were DOS based. I sincerely appreciate the help.

Here is another good resource . RSLogix500 Getting Results.
A little old, but should help.

Here's another one for RSLinx

Aren't we helpful, you now have about 6 months of reading material now.

http://literature.rockwellautomation.com/idc/groups/literature/documents/gr/linx-gr001_-en-e.pdf

Mickey said:

Here's another one for RSLinx

Aren't we helpful, you now have about 6 months of reading material now.

http://literature.rockwellautomation.com/idc/groups/literature/documents/gr/linx-gr001_-en-e.pdf

Click to expand...

Overwhelmingly helpful. Thanks you very much guys.