Issue of PG/PC interface

ggchavhan

Member
Join Date
Nov 2006
Location
pune
Posts
135
Dear All

I have Windows 7 Proffessional 64 bit. I installed Simatic Manager V5.5 Sp1, everything fine except PG/PC Interface.
I want to connect thru USB MPI adaptor, but it is showing PC Adaptor (MPI).1 This .1 extention is for all the drivers.
If I select that it dont show properties of the drivers.

It works fine with Windows 7 Ultimate 32 bit.

My question is that, is it issue of Windows 7 Proffessionl 64 bit?

if not

What is the solution??
 
Last edited:

Similar Topics

I have a 1761-net-ini connected to a slc504. I have been talking to it wireless over a bridge, for about a year. The wireless is very unstable, so...
Replies
5
Views
2,273
Hi Folks, I am not able to communicate to BEI Ideacod Absolute encoder with the Counter Module. Issue is as i Enable Direct Enable command in...
Replies
0
Views
2,445
Rockwell Tech Support seemed to have hit a wall with this question. Already updated the version to 5.00.13 per their suggestio but am still...
Replies
1
Views
58
We have a problem where client wrongly install inverters in their residence, this then prevents the elec meters(Hexing hxp100Dii) from...
Replies
0
Views
69
Hello all. I need some help on DLR issue we encountered which is the DLR not working when supervisor is disconnected from the ring. FIrst of all...
Replies
4
Views
102
Back
Top Bottom