Address specified to bit level

Hello
I have a question about timers.
I have timers located in my program that seem OK.
But when I go to reference them in a different rung I get this message.
(Address must be specified to bit level.)

T4:5 Is how the timer is identified.And on a different rung it is referenced to be checked as [/] in the rung.When I place the timer T4:5 The above message is displayed.

Any and all nudging in the right direction is much appreciated.

If you're looking for when it is done timing try T4:5/DN

Press F1 while the timer is highlighted and see all the bits that you can reference from a timer.

Shawn

Thank you.
That was what I as looking for.
It's the stuff that look's you right in the face that winds up slapping you.

We've all been there. I sometimes revisit those times myself.