Mitsubishi FX temp control

Hi
I need to know how can i connect a Pt100 4wire temp sensor [or Pt1000 2 wires ]to FX family PLC
i am using FX1S (can upgrade if needed)
all modules mention 3 wire Pt100 ,or thermocuple

thanks

You should have 2 red wires & 2 white, connect either the 2 reds or the 2 whites together it then becomes a 3 wire probe, the wires are connected in the tip anyway & are used to compensate for the cable, as the analog conversion is 12 bit the accuracy is more than you will probably need.