how to connect fx2n and E 500 inverter via Rs 485

nadeemalik

Member
Join Date
May 2011
Location
pakistam
Posts
6
hi
i m new in plc programming.
i want to connect the fx2n plc with fr-e 500 inverter via rs 485.
i have searched a lot on internet but could find a good example.
i m using a Fx 485 BD card on Fx2nc plc.
i want to know what registers are involved in doing this.
my goal is to send frequency ref and run command of inverter from plc via rs 485.

plz reply
 

Similar Topics

Yup they don't have any Ethernet posts on them but would like to try and see if I can get them to connect to a network to get certain info on the...
Replies
8
Views
2,328
hi dear in E300 PROG/SETUP is deasabled by command line. now how can i enable it again?also is any setting to connect a new E300 to FX?
Replies
0
Views
1,488
Hello to all, I recently changed out our fx2n with an fx3u and now unable to connect, I did change the setting in the program with the new plc...
Replies
1
Views
2,384
Hello, friends, I am trying to upgrade a system that uses an Onrom incremental encoder (E6B2-CWZ6C) connected to a Danfoss VFD (FC360), but now...
Replies
4
Views
245
I will find cable series but I don't know for fs260 model, kindly suggestions and help to me for connect cable
Replies
1
Views
95
Back
Top Bottom