HarleyRay0
Member
On the push of a reset button i would like to zero a range of DBW's :
DB200.DBW4 -> DBW200
Is there a standard way of doing this?
Ray
DB200.DBW4 -> DBW200
Is there a standard way of doing this?
Ray
S7-313C-2DP Clearing DB area to zero?
- Thread starter HarleyRay0
- Start date
L D[AR2P#0.0]
Lifetime Supporting Member
Use SFC21, example below:
HarleyRay0
Member
OP
Thanks Very much. All works!
Cheers,
Ray.
Cheers,
Ray.
PeterW
Member
There is a SFB (or SFC, can't remember the number) that sets a range of words to a preset value. I believe its called 'FILL'
Similar Topics
Hi every body,
i am goning to change cpu313c 2dp instead of cpu 314.
Is it possible?
What shuld i do?
Please help.
Regards
I am using a Siemens CPU313C-2DP to communicate to a network of Control Techniques UnidriveSP drives by way of a SM-Profibus module (new...
CPU 313c-2DP all LED got flashing. That time all output gets deactivated. After total power reset only it get's comes stop mode. Then its goes...
Hi,
I want to have a retentive marker word in a 313C-2DP. I have set up retentive memory in the properties of the PLC in the hardware config to be...
Hello:
I have CPU313C-2DP , I want to operate it 20 hour separeatlly every 24 hour
how I can do that?
