step 5 question

zmun

Member
Z
Join Date
Aug 2006
Location
tamparuli
Posts
1
I have one old project file which was created using very old PG. I have one problem now, whenever i try to open the symbol file using a new Step 5 i will get the following message

OLD DVS file (created with DVS 1)

what is DVS and how to overcome this problem?
 

Similar Topics

A
Question about BLKMOV instruction in STEP 7
Hi everyone, I have a short question about BLKMOV instruction, illustrated in the image below. I have the same piece of code in STEP 7 (ET200S)...
Replies
2
Views
2,734
JesperMP
JesperMP
BachPhi
Step 7 and Addressing a DB question
When looking at the DB declaration ( see below pic), I did not see addresses like DB108.DBX203.0 or DB108.DBX205.0 and so on .... and yet they...
2
Replies
15
Views
3,297
Lare
L
N
Question about Siemens Step 7 PID
Is it Gain or Proportional band? The HMI shows it as Proportional Band and the tag name is Gain???
Replies
3
Views
2,171
NetNathan
N
AutomationTechBrian
Troubleshooting Siemens HMI w/Step 7, & WinCC/Redlion HMI question
Tomorrow morning I have to use a rented Siemens PC to troubleshoot a Siemens HMI, programmed with WinCC, communicating to a couple of ABB drives...
Replies
5
Views
10,177
RMA
RMA
M
Step 7 Question using Inputs and Any Pointer
Hello Folks! I'm still trying to get the hang of using STL and Pointers in Step 7 (V5.5). For background, I'm writing a sample application...
Replies
7
Views
3,294
Matchu04
M
Back
Top Bottom