help plc ABB AC 500 PM573 CODESYS

Fran_Spain

Member
F
Join Date
Jan 2012
Location
Spain
Posts
1
Greetings from Spain ..

Help with AC 500 ABB plc.

I have the need to replace a cpu PM573 PM 581 on the other, the reason is a breakdown ...

PM573 cpu is new from the factory, and I can not configure the TCP / IP address, not detected 'IP config' CoDeSys.

Do I have to assign any local timber address? As can be 0.0.0.0

thanks
 

Similar Topics

P
help me to send data from ML1400 to ABB PLC
Hi, I want to send the data from ML1400 to ABB PLC. Can anyone help me to send the data through MSG instruction setup. Best Regards, Prasanna
Replies
1
Views
1,361
Ken Roach
Ken Roach
A
help me plz tell me how to interface srvo motor with ABB micrologic 1400B plc
sir plz tell me how to interface servo motor with abb micrologoc 1400b plc plz give me detail of instruction and wht type driver may i use or tell...
Replies
5
Views
2,499
danatomega
D
D
help please: set PLC ABB AC500 with touch Panel KINCO MT4620TE
i need some help. im trying to communicate a PLC AC500 with a touch panel KINCO MT4620TE I have tried with ethernet with modbus TCP slave...
Replies
0
Views
2,409
Don isra
D
D
help: set PLC ABB AC500 with touch Panel KINCO MT4620TEhello everybody
i need some help. im trying to communicate a PLC AC500 with a touch panel KINCO MT4620TE :banghead::banghead::banghead: I have tried with ethernet...
Replies
0
Views
2,081
Don isra
D
R
ABB robot EthernetIP to PLC & HMI help needed
HI All. Hope you all had a good Easter. Was going to order some some new ABB IRC5 robots, which normally come with DeviceNet option and some IO...
Replies
9
Views
14,762
rigicon
R
Back
Top Bottom