Hello,
I have a PH transmitter that is supposed to be panelmounted. The cut out is 90*90 mm. This is some standard measure as I understand.
However I do not wan't to panelmount it instead I wan't to wall mount it. However the supplier for the transmitter has no housing that can be used for this.
Any one have any suggestions. And no, I do not wan't to by a housing and make my own hole since it is about 100 seperate units and there has to be some kind of standard housing I would imagine. Plastic is fine.
I have a PH transmitter that is supposed to be panelmounted. The cut out is 90*90 mm. This is some standard measure as I understand.
However I do not wan't to panelmount it instead I wan't to wall mount it. However the supplier for the transmitter has no housing that can be used for this.
Any one have any suggestions. And no, I do not wan't to by a housing and make my own hole since it is about 100 seperate units and there has to be some kind of standard housing I would imagine. Plastic is fine.