pietervdb
Member
Hello,
I need to program a CU240E v4.4 with a PM240 power module and a BOP-2.
The client wants following DI mapping.
DI 0: Start remote, setpoint comes from AI1
DI 1: Spare
DI 2: Reset
DI 3: Feedback forced cooling
DI 4: Start local, setpoint comes from BOP-2 with the arrows
DI 5: Switch local/remote. (1 = Remote)
The forced cooling start automatically.
Now he wants to work with the following procedure.
1) If switch is on remote, and the start remote is 1 and the feedback from the forced cooling is 1, then start the drive with setpoint coming from AI1.
2) If the switch is on local, and the start local is 1 and again feedback forced cooling is 1, then start the drive with the setpoint selected on the BOP-2.
Is this possible with Simotion Starter/Scout?
I know in the expert list you have P20000 to P20399 to combine signals but is it possible to select different setpoints?
I need to program a CU240E v4.4 with a PM240 power module and a BOP-2.
The client wants following DI mapping.
DI 0: Start remote, setpoint comes from AI1
DI 1: Spare
DI 2: Reset
DI 3: Feedback forced cooling
DI 4: Start local, setpoint comes from BOP-2 with the arrows
DI 5: Switch local/remote. (1 = Remote)
The forced cooling start automatically.
Now he wants to work with the following procedure.
1) If switch is on remote, and the start remote is 1 and the feedback from the forced cooling is 1, then start the drive with setpoint coming from AI1.
2) If the switch is on local, and the start local is 1 and again feedback forced cooling is 1, then start the drive with the setpoint selected on the BOP-2.
Is this possible with Simotion Starter/Scout?
I know in the expert list you have P20000 to P20399 to combine signals but is it possible to select different setpoints?
