cant see the OW8 outputs in micrologix 1200

matlark

Member
Join Date
Jul 2011
Location
KY
Posts
102
When I go into the output datafiles I cannot see the two additional 1762-OW8 output modules. Do I need to initialize them or something for a new program?

thanks
 

Similar Topics

I have a sysmac omron plc C200H CPU01,only the power led is ON,using CX-ONE programmer software, and connecting to the plc via Host link LK202-V1...
Replies
2
Views
668
Good morning, we have a lot of coolant mist around our machines and sometimes the fans on the drives inside our electrical cabinets will suck the...
Replies
7
Views
1,260
I cannot get CCW to add a controller, i keep getting a error message saying that the device is not authorized. This happens with any model and...
Replies
1
Views
1,267
Hey guys, Frustrating issue here. I have one particular PC with Proficy 8 installed that no matter what I try, I cannot get the variable...
Replies
6
Views
1,371
Hello Everyone i got a problem with Endress Hauser FlowMeter Promag W400, in his specification says it support Ethernet/IP protocol...
Replies
4
Views
1,726
Back
Top Bottom