Mitsubishi Instruction ---|STL|---

gbradley · Apr 9, 2012

I attached a .jpg of the printed ladder in question.
There is a Load, or Examine On instruction.
In between the vertical bars are the letters STL...---|STL|---
As I am entering in the instructions, I don't see an option to display ---|STL|---
How can I display this?
Or is the ---|STL|--- a completely different instruction, than ---| |---?

I entered it with a standard instruction, so I wonder if it will work the same.
------
All I have is a hard copy of a ladder file printed on paper.
I can't get to the processor right now, so I am writing a ladder file with GX developer.

I just ordered GX-Works2-C1 for the PLC and GT-Works3-C1 for the HMI.
In the meantime, I am practicing with the GX developer Programming and Maintenance tool version 8.25B
Thanks

iant · Apr 9, 2012

Hi Mate
in the old Melsec this is the MCR (master control)

melsec the contact was shown in the LHS rung @ 90 degrees
this is what it will be

gbradley · Apr 9, 2012

iant said:
Hi Mate
in the old Melsec this is the MCR (master control)

melsec the contact was shown in the LHS rung @ 90 degrees
this is what it will be

Sorry, I don't follow.
I don't know what the LHS rung is.

I figure that this is similar to the Stage instruction in Directsoft.

iant · Apr 9, 2012

left hand side (power) rung
similar to using the AB conditional JSR routines

iant · Apr 9, 2012

have a look at this PRG
imported to GX dev from Melsec

EDIT = PG 11

BTalbot · Apr 9, 2012

The original jpg looks like it is from Medoc(dos). In GX Developer you would just have a |----------[STL S10]--| and then your logic.
see attached

Mitsubishi Instruction ---|STL|---

gbradley

Lifetime Supporting Member

iant

Lifetime Supporting Member + Moderator

gbradley

Lifetime Supporting Member

iant

Lifetime Supporting Member + Moderator

iant

Lifetime Supporting Member + Moderator

BTalbot

Member

Similar Topics