Crimson 3.0 Emulator through Modbus to Click via Keyspan USA-19HS

Can be it done?

Please yesterday ugernt answer send.

I guess I should just ask if anyone can help with driver settings to use the the Click Programming port (fixed Modbus, 38400, 8, Odd, 1) and how I should configure the Red Lion to communicate. This is my first time with Modbus RTU to a HMI.

dont have the click stuff on this laptop but i am glad your finding to play!

The Click handles Modbus RTU (not Modbus ASCII) natively. So I don't see why not.

This might help:

http://www.aboutplcs.com/click/click_help/181.htm

I just did a little project using a G304K and Click. Attached are the settings I used. I set up the G304K as the master, so aside from one rung of start/stop logic in the PLC, my entire program runs in the G304K.

You should have ZERO trouble getting this to work, Paul...



-Eric

Totally off topic, but worth mentioning...

I didn't have the Click software installed on my home PC, and my version of the Crimson software was that 'non-genuine' build. Therefore, in order to look at my programs, I had to download and install both pieces of software.

Downloading AND installing BOTH took me LESS THAN FIVE MINUTES!!!... Why is it that the 'other brand' software takes F-O-R-E-V-E-R to install?!?!?!

Thank you, Red Lion and A-D (or Koyo, or Host, or whoever wrote the Click software). Well done!...



-Eric

Thanks for the tips. I believe I may have a conflict related to various drivers on my home PC preventing the driver from working through the G3 Emulator.

I may tinker with it more later this week.

OkiePC said:

Thanks for the tips. I believe I may have a conflict related to various drivers on my home PC preventing the driver from working through the G3 Emulator.

I may tinker with it more later this week.

Click to expand...

How do you have the emulator configured? Modbus should work just fine through the emulator.