HELP: Oriental Motor Problem

renHiatus · Jun 16, 2012

I have here ARD-KD stepper motor driver and ARM66SMK-T10-2 motor from Oriental Motor. I already 'teach' motor position in MEXE02 software, and so far it works well. unfortunately, I have a problem controlling it via PLC. I already perform direct I/O signal from PLC to Motor's driver but nothing happened.

Please help, newbie here

KalleOlsen · Jun 16, 2012

renHiatus said:
I have here ARD-KD stepper motor driver and ARM66SMK-T10-2 motor from Oriental Motor. I already 'teach' motor position in MEXE02 software, and so far it works well. unfortunately, I have a problem controlling it via PLC. I already perform direct I/O signal from PLC to Motor's driver but nothing happened.

Please help, newbie here

I'am not sure if you ask for PLC help or motor driver help. Since you don't mention the PLC type, I recon it is the latter.

Does the motor driver respond if you latch directly on the driver inputs? Could it be you have forgotten to connect the power supplies M (0 V)?

Kalle

chavak · Jun 17, 2012

As Kalle mentioned, check your input/output common in the configuration drawings.
If I am not wrong, most of the Oriental motor stuff comes with +ve as common, maybe some with configurable.

Regards
______

renHiatus · Jun 26, 2012

Thanks for the kind responses, we figured that it was just a 'common' problem

Thank you!
Ren.

HELP: Oriental Motor Problem

renHiatus

Member

KalleOlsen

Member

chavak

Member

renHiatus

Member

Similar Topics