gkoedel
Member
I thought I saw a thread on here around 2008 where a few people were able to do away with the SC-09 Mitsubishi PLC cable and go wireless to their PC. Anyone have any thought or know how to do it?
Thanks,
Thanks,
Wireless programming Mitshubishi PLC
- Thread starter gkoedel
- Start date
BTalbot
Member
Similar Topics
Wanting to use a wireless setup for programming between pc and mitsubishi serial connections. Want to get away with cables. Any advice.
I have done some research on this subject but havn't quite seen the situation I am wondering about.
Typical situation:
Controls cabinet...
Is anyone using an In-Plant wireless network between their laptop and PLC's, or LAN system, to program or on-line edit programs?
I was...
Hello Y'all,
I was wondering if there is any standalone solution to replace the ethernet cable to connect to a PLC? like perhaps a "Dongle"...
I know this can be done, but I can't get the router config right.
My goal is to physically connect(using an ethernet cable) a device(PLC, RTU...
