gaurangparikh
Member
pls tell solution
CPU 315T shows question mark in HW configuretion
- Thread starter gaurangparikh
- Start date
alielectrical
Member
Gaurang,
I presume that your software is not latest, What is the version of your software?
Can you verify the version that the program was made with.
Regards,
ali
I presume that your software is not latest, What is the version of your software?
Can you verify the version that the program was made with.
Regards,
ali
Similar Topics
Hello dear sirs,
I'm using Technology CPU for the first time. My job now is to bind this cpu with CU310DP over profibus.
For this I'm using-...
hello
s7-400h and wincc are connected to each other via Ethernet.
I need help on how to do time synchronization
I'm struggling to get an FR-E800SCE to work on CC-Link IE TSN. I'm sure the issue is with the drive, when I plug in the network cable I get no...
Hi , Where i can find Mitsubishi PLC Card end of line & replacement model details. i am looking for Q02CPU replacement model. Please advice. thanks
hi...
i have an issue in s7 300 plc, while we run the machine(in idle there is no fault) , plc cpu goes in SF mode, after restart the power cycle...