i have Daniel flow computer Flow boss (device ID-32) is communicating on RS485 with GE FANUC 90-70 PLC(PCM 711 card). The flow computer is getting updated properly in milliseconds. But in the PLC the data are not updating properly. The PLC holds the last value and automatically after 5-10 minutes its starts updating. The PCM cards, all LED is found ok.
The Flow computer was checked on the modbus simulation software and found updating properly. It seems the problem is from PLC site which is to rectify.
The Flow computer was checked on the modbus simulation software and found updating properly. It seems the problem is from PLC site which is to rectify.