spaderkung
Member
I heard from someone that Siemens recently recommends another PID control block instead of CONT_C, for continuous control. Any truth in that?
S7-300 FB41 obsolete?
- Thread starter spaderkung
- Start date
Similar Topics
HI.I REVIEWED A PROJECT DONE. THIS FB41 PID BLOCK WAS USED FOR THE PASTEURIZATION PROCESS. THE PROCESS I CAN'T UNDERSTAND IS THE ACTION. WHILE THE...
hello,
I'm new in automatics, and i'm working on a speed control project for a hydraulic turbine.
i'm using FB41 pid bloc, but the LMN give me 0...
Hello,
Please see attached pictures and tell me why does the output change can you please pin point my mistake i have been searching the net for...
Hello all,
I am an electrical engineering student working on a senior design project with an industry sponsor. We are automating a burst test...
Have a system that has been running for over a year and all of a sudden getting a ExcessiveVelocityFault on one of the drives when the MSO command...