kexlington
Member
Hey,
I have one of these brand new Micro800 series of PLCs from Rockwell (a Micro830 to be exact). Our project needed a few more outputs, so I thought I would add a 2080-OW4I 4 relay output module... Easier said than done...
In CCW, when I right click on the picture of the controller to add the module, my plug-in module does not show up in the list (see picture). In fact, only a few out of all of the possible plug in modules show up on the list.
Has anyone else had this problem? I have the latest version of the software. There was a sheet that came with the plug-in module mentioning something about user defined function blocks, but I can't find these on my computer or where to download them!
I have one of these brand new Micro800 series of PLCs from Rockwell (a Micro830 to be exact). Our project needed a few more outputs, so I thought I would add a 2080-OW4I 4 relay output module... Easier said than done...
In CCW, when I right click on the picture of the controller to add the module, my plug-in module does not show up in the list (see picture). In fact, only a few out of all of the possible plug in modules show up on the list.
Has anyone else had this problem? I have the latest version of the software. There was a sheet that came with the plug-in module mentioning something about user defined function blocks, but I can't find these on my computer or where to download them!