Paradigm_shift
Member
Good Morning Sirs,
I'm using a MVM instruction to turn on/off my PLC's outputs. I'm using, meanwhile, the outputs O:2/0 to O:2/3.
Then I use my MVM instruction just with the first 4 bits of a B3:122 moving it to my O:2.0.
The problem is, the first three outputs worked fine when I started the program, but when I need to turn on the O:2/3 the MVM seems not to move my bit to the output.
Is there something missing?
The ladder I'm using is:
I'm using a MVM instruction to turn on/off my PLC's outputs. I'm using, meanwhile, the outputs O:2/0 to O:2/3.
Then I use my MVM instruction just with the first 4 bits of a B3:122 moving it to my O:2.0.
The problem is, the first three outputs worked fine when I started the program, but when I need to turn on the O:2/3 the MVM seems not to move my bit to the output.
Is there something missing?
The ladder I'm using is: