pilz pnoz m1p ETH to ABL35 communication

How to add Pilz m1peth with allen bradly L35

I hope you're talking about a L35e CPU...
In your I/O configuration you add a Generic Ethernet Module.
In the pop-up you have fill in the IP adress of the Pnoz Multi, and the connection parameters.
These parameters are: Input 100 size 20, Output 100 size 20 and Configuration 4 size 0.

I'm not sure if there is an EDS file for this PIlz today, but this is how it works in our factory.

Jack

Hello,
I'm trying to connect a Pilz PNOZ m1p ETH with a AB CompactLogix 1769-L33ER.

I tried to use your solution, but the connection doesn't work.

What kind of data are you using DINT, SINT, INT?
How many bits I must set in the Pilz Config Internal Port? (24,128)

Thank you
Lorenzo

We use Data - Sint
Our Pilz version allows only 24...

I see Output size is 150 instead of 100.

Well, it is what I done.

In the images there are my configurations. I think that all is correct.

The CPU gives me the error N° 16#0204 (Timeout connection).
If I make a ping to the Pilz, it responds.

Have you got any other idea?








But are you using an mc8p interface?

Put the Output Assembly Assistance on 150...