hoejinkim
Member
Hi
I am trying to communicate PLC with Roborealm(another software) through Modbus TCP/IP (*Roborealm is an application for use in computer vision, image analysis, and robotic vision systems)
I put PLC on master and Roborealm on slave. However I don't know how to have them communicate each other through Ethernet cable(crossover cable).
I've read manual on automationdirect.com, but I don't understand at all.
Does anyone know this?
First attached file is picture of Roborealm in terms of the modbus TCP/IP slave
I am trying to communicate PLC with Roborealm(another software) through Modbus TCP/IP (*Roborealm is an application for use in computer vision, image analysis, and robotic vision systems)
I put PLC on master and Roborealm on slave. However I don't know how to have them communicate each other through Ethernet cable(crossover cable).
I've read manual on automationdirect.com, but I don't understand at all.
Does anyone know this?
First attached file is picture of Roborealm in terms of the modbus TCP/IP slave